新闻动态
新闻动态 当前位置:首页>新闻动态>新闻动态

工业污水处理设备的开停次数不可过于频繁

网址:www.waterqz.com.cn  2019-11-14  作者:admin    阅读:

1、保证来水量与抽升量一致。如来水量大于抽升量,上游又没有及时采取溢流措施,则可能淹泡格栅间,甚至使市区地势较低的下水道返水,反之,如来水量小于抽升量则有可能使泵处于干运转状态,损坏设备。
1. Ensure that the water inflow is consistent with the pumping capacity. If the water inflow is greater than the pumping capacity, and the upstream does not take overflow measures in time, it may flood the grid room, or even make the sewer return water in the lower urban area. Otherwise, if the water inflow is less than the pumping capacity, it may make the pump in the dry operation state and damage the equipment.
2、应保持集水池高水位运行,这样可降低泵的扬程,效率高,在抽升量的前提下降低能耗。
2. Keep the high water level of the sump running, so as to reduce the pump head, high efficiency and energy consumption on the premise of pumping capacity.
3、工业污水处理设备的开停次数不可过于频繁,否则损坏电机并降低使用寿命。
3. The start and stop times of industrial sewage treatment equipment shall not be too frequent, otherwise the motor will be damaged and the service life will be reduced.
4、工业污水处理设备内每台污水处理设备的投运次数及时间应基本均匀,因为每台污水处理设备的吸水口都对应着集水池内的一部分容积。
4. The operation times and time of each sewage treatment equipment in the industrial sewage treatment equipment should be basically uniform, because the water intake of each sewage treatment equipment corresponds to a part of the volume in the water collecting pool.

转让电话
13313028229